hotend - K-Thermistor vs Ender 3 Stock Thermistor: Problem with

I have changed my hotend on my Ender 3 v2 with Dragonfly BMS. In effect, because I wanted to reach higher temperatures, I also changed the thermistor with one that is 3mm wide and does not have the

Thermistor broke , what can I do? : r/ender3

Ender 3 - Getting 300°C + Print Temperatures for Polycarbonate and Nylon Printing

Ender 3 V2 Neo The current hot bed and nozzle temperature is too high : r/Ender3V2NEO

The heating tube has XH2.54 interface, and the resistance has XH1.25 interface, which is easy to replace and install. Compatible Models: Ender 3 1S

Creality Ender 3 S1 Pro Heating Tube and Thermistor, 24V 50W Heating Tube Thermistor Kit for Ender 3 S1 Pro, CR-10 Smart Pro (Heating Tube+Thermistor)

Wire Length: 51.1inch /1.3m. The package includes 5 3D printer thermistors. 2-pin XH2.54 female connector. Note Before Buying: Our Ender 3 thermistor

5PCS Creality 3D Printer NTC Thermistor 100K, NTC 3950 100K ohm Thermistor Temp Sensor for Creality Ender 3/Ender 3 Pro/Ender 3 Neo/Ender 3

troubleshooting - Diagnosing sudden problem with hotend temperature - 3D Printing Stack Exchange

Glob nightmare, broken thermistor wire and can't remove hot end : r/AnkerMake

Slice engineering 300°C Thermistor - 3DJake International

CRTouch and Creality Spider Hotend support (both on one firmware file) · Issue #24134 · MarlinFirmware/Marlin · GitHub

hotend - Anet A8 reading 739°C from the extruder thermistor! - 3D Printing Stack Exchange