Serre-joints d'angle Rockler Clamp-It Rockler 594092 : Outillage professionnel pas cher, bricolage et visserie discount

Rockler Clamp-It Clips, 4-Packs Rockler Woodworking and Hardware

Slips over the top edges of any two panels, holding them at a 90° angle while you drive the nails or screws.

Rockler Clamp-It Clips, 4-Pack

Serre-joint d'angle 50496 Clamp-It - 594092 - Rockler

Our Small Corner Clamping Jigs hold thin boards at a perfect right angle, helping you achieve tight corners with minimal fuss. You can use them to clamp glued miters (with no fasteners), or as third hands to hold the joint closed while you drive brads or pins. They hold material from 1/4'' to 1/2'' thick use scrap 1/2'' stock to provide support if needed Note: Not compatible with the Rockler Mini Clamp-It Assembly Square (#27767, sold separately), nor is a separate square necessary.

Rockler Clamp-It Small Corner Clamping Jig, 2-Pack

Rockler Clamp-It® Corner Clamping Jig

Rockler Clamp-It Small Corner Clamp Jig (2-Pack) - Right Angle

Rockler Adjustable Clamp-It Assembly Square

Rockler Clamp-It Corner Clamp Jig - Glass-Filled Polycarbonate

Lining up panels at a 90 angle while you drive nails or screws can be an exercise in frustration. Pieces tend to shift around, and your fingers are often too close to the business end of the nailer for comfort. That's where the Rockler Clamp-It Clips provide a welcome helping hand. They slip over the top corner of any two panels, holding them in perfect alignment while you drive the nails, screws or apply clamping pressure. They are available for two stock thicknesses: 1/2'' and 3/4''.